Oven – How to replace the oven switch

Resolution

Always refer to the safety information in your product’s user manual before carrying out any repair or maintenance.https://www.electrolux.com/support/user-manuals/

WARNING!RISK OF ELECTRIC SHOCK

Before carrying out any repair or maintenance, switch off the appliance and unplug it from the socket.

WARNING!RISK OF INJURY

Always take care when moving appliances. For heavy appliances it’s safest for two people to move them. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect against cuts from sharp edges.

WARNING!RISK OF EYE INJURY

Wear safety glasses if you’re doing any maintenance or repair work that involves springs.

WARNING!RISK OF BURNS

Before carrying out any repair or maintenance, make sure the appliance is not hot.

WARNING!CHOKING HAZARD

Small parts. Not suitable for children under 3 years. Keep all small parts and packaging out of reach of children.

Only adults should use or install the product.

Make sure to use the product only for its intended purpose and check that it’s a compatible part for the product you’re using.

Do not use or install the product if it is damaged.

Please note that doing repairs yourself or using someone who isn’t a qualified professional can have safety implications if not done properly and may void the warranty. It’s essential that you have the proper know-how.

HOW TO REPLACE OVEN SWITCH

1. Unscrew the two Torx 20 screws at the top of the panel and lift the two back panel tabs out of their securing slots at the bottom of the oven.

2. Unscrew the three Torx 20 screws on the right-hand side of the lid.

3. Repeat on the left-hand side and lift the lid off.

4. Take hold of the control knob and pull it off the selector switch shaft.

5. Unscrew the two Torx 20 screws to release the oven switch inside the appliance.

6. Carefully disconnect the wiring connectors from the oven switch spades to remove them. (Note: Take a photo of the wiring layout/position before disconnecting. It’s very important that the wiring is put back in the correct position for the appliance to work properly. Take care not to damage the connectors.

7. When reassembling, repeat the steps in reverse order.