How to replace fan/ring heating element (3)
Resolution
Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/
WARNING! RISK OF ELECTRIC SHOCK
Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
WARNING! RISK OF INJURY
Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.
WARNING! RISK OF EYE INJURY
Wear safety glasses if you perform maintenance or repair work involving springs.
WARNING! RISK OF BURNS
Before any repair or maintenance operation make sure the appliance is not hot.
WARNING! CHOKING HAZARD
Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.
Only adults should use or install the product.
Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.
Do not use or install the product if damaged.
Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.
HOW TO REPLACE FAN/RING HEATING ELEMENT
Before replacing any part of the appliance remove the door when the appliance is still mounted in the furniture. Door removal is described in the User Manual.
Screw placement and their number may differ depending on appliance.
1. Remove the back panel – to do that unscrew the screws for the back panel and if needed the screws for the hob top. Then remove the back panel by pulling the bottom away from the body of the appliance.
2. Gently pull the vent hoses away from the vent exit (release the jubilee clip if included).
3. Carefully disconnect wiring connector from the heating element spade. (Note: Take a photo of the wiring positioning/location before disconnecting) Be careful not to damage the connector.
4. Inside the oven unscrew the screws holding the fan cover and remove it, ensure that all the washers are with all the screws.
5. Unscrew the twoTorx 20 retaining screws from the heating element and carefully pull the element away from the cavitytowards the door to remove.
6. When reassembling, repeat steps in reverse order.