How to replace the control box (9)
Issue
How to replace the control box
Applies to:
- cooker hood
Resolution

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK
Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.


WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! CHOKING HAZARD
Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.
Only adults should use or install the product.
Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.
Do not use or install the product if damaged.
Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.
How to replace the control box
1. Remove the filter
Pull down the latch in the handle structure to unsnap the filter.

Alternative filter: Slide the latch in the handle structure backwards to unsnap the filter

2. Remove the metal frame
Unsnap the Lamp connectors and pull in opposite direction.
Push the 2* Stops forward to unhook the frame

Slider control box

Unfasten 2 screws that secure the control box to the hood body.
Unsnap to remove the led driver.

Disconnect the control box from the led driver
Cut 2 cable ties.

Disconnect the control box from the fan
Unfasten 1 screw that secure the Power Connection Box Cover

Loosen 2 screws that secure the cables.
Pull out the cables from inside the hood body and extract the control box.

Electronic control box
Disconnect the power supply

Remove the filter and metal frame (step 1 and 2)
Unfasten 2 screws that secure the control box to the hood body.
Pull out the flat cable junction.
