How to replace the control box (8)
Issue
How to replace the control box
Applies to:
- cooker hood
Resolution

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK
Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.


WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! CHOKING HAZARD
Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.
Only adults should use or install the product.
Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.
Do not use or install the product if damaged.
Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.
How to replace the control panel
Disconnect the power supply!
1. Remove the lower panel. Slide to the left to unsnap the lower panel.

2. Remove the filter. Slide the latch in the handle structure backwards to unsnap the filter.

3. Remove the lower panel holder. Unfasten the 4 screws.

4. Remove the lamps. Press sequentially from both sides to unsnap the lamp. Extract the lamp. Unsnap the lamp connector.

5. Remove the frame. Unfasten 4 screws Unfasten 2 screws which secure the frame to the hood.

Unfasten 1 screw which secure the Frame to the hood

Unfasten 2 screws which secure the holder of the control panel to the frame.
Unfasten 1 screw which secure the holder of hood to hob assembly the Frame.

6. Control assembly. Unsnap the hood to hob cover. Unsnap the control box bus cable.
