Washing machine displays error message E90, E91, E92, E93 or E94
Resolution
Issue
- Washing machine displays error message E90, E91, E92, E93 or E94. It indicates configuration / communication problems with the electronic parts.
Applies to
- Front loader washing machine (integrated and freestanding)
- Top loader washing machine
Resolution
1. Reset the appliance.
Remove the plug from the socket, wait 30 seconds and then plug it in again.
2. Contact an Authorized Service Center.
If the above suggestion did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- Washing machine displays padlock - Electrolux
- Connected appliances - The application cannot connect to the appliance
- Washing machine stops in the middle of a cycle
- Washing machine displays error message E40, E41 or emits 4 beeps / 4 flashes
- The door of the washing machine cannot be opened
- The washing cycle is shorter / longer than indicated on the display
- Washing machine displays error message E30, C3 or emits 3 beeps
- Connected appliances - problems with onboarding
- Washing machine does not drain, displays error code E20, E21 or C2, emits 2 beeps / 2 flashes
- Why is there water or moisture is in my washing machine before the first use?