It takes too long for a dishwashing cycle to start
Resolution
If it takes too long for a dishwashing cycle to start, refer to the suggestions below for step by step instructions.
- When you start a cycle, it can take up to five minutes to fill the softening unit.
- During this time, it may seem that the appliance is not working.
- The liquid phase is first to start once this procedure has finished.
Was this article helpful?
Related Articles
- How to set the programme with QuickSelect on your Electrolux dishwasher
- Dishwasher is making unusual noises
- Dishwasher displays error message C2, F2, i20, AL6, beeps 2 times or LED flashes 2 times
- Rust spots on cutlery after washing in the dishwasher
- Dishwasher does not / will not start but the power is on
- Water is being filled into the dishwasher even when it is turned off
- Dishwasher displays error code iC0 - Causes and Fixes
- Dishwasher does not switch on, no light on the panel
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Dishwasher displays error message iF0, iFo or iF1
Related Articles
- How to set the programme with QuickSelect on your Electrolux dishwasher
- Dishwasher is making unusual noises
- Dishwasher displays error message C2, F2, i20, AL6, beeps 2 times or LED flashes 2 times
- Rust spots on cutlery after washing in the dishwasher
- Dishwasher does not / will not start but the power is on
- Water is being filled into the dishwasher even when it is turned off
- Dishwasher displays error code iC0 - Causes and Fixes
- Dishwasher does not switch on, no light on the panel
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Dishwasher displays error message iF0, iFo or iF1