Dishwasher - How to replace the main board (2)

Applies to:

  • Dishwashers

Resolution

Always refer to the safety information in your product's user manual before carrying out any repair or maintenance work. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, turn off the appliance and unplug it from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF PINCHING

Wear safety gloves if you're doing any maintenance or repair work on belts.

WARNING! CHOKING HAZARD

Small parts not suitable for children under 3 years. Keep all small parts and packaging away from children.

Only adults should use or install the product.

Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE ELECTRONIC BOARD

1. NOTE: This repair necessitates the removal of the decor door before commencing the repair.

2. Open the dishwasher door. NOTE: Only use hand tools for this and be careful not to over-tighten during reinstallation, or you'll break the screw lugs on the control panel.)

3. Unscrew the screws at the top of the inside door panel. Depending on the model there are 5 or 6 screws connecting the control panel to the door.

4. Gently pull down the control panel away from the door to expose the inside of the control panel.

5. Using a flat blade screwdriver, gently prise open the two clips on either side of the circuit board and then slide the circuit board down to release from the control panel.

6. NOTE: Transfer any buttons from the previous circuit board/control panel to the new circuit board.

7. Carefully use a small flat blade screwdriver to lever out the plug connector (NOTE: Be careful not to damage the connectors. Take a photo of the wiring positioning/location before disconnecting).

8. When putting it together, do the steps backwards like.

Was this article helpful?

Book a service

Having issues with your appliance? Book a reliable and professional service from our expert technicians to get your product up and running.

Book a service

Spare parts & Accessories

Find original spare parts for your appliance in our webshop and have them delivered directly to your door.

To the webshop

Find your product manual

Solve problems and look up instructions or other documentation for your product.

Find manual