Dishwasher - How to replace the basket bracket

Resolution

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! NOT INTENDED FOR CHILDREN

Keep all small parts and packaging out of reach of children under 3 years due to choking hazard. Installation and use should be performed by adults only.

-

Before any repair or maintenance operation, turn off water supply to the appliance.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE THE LOWER BASKET BRACKET

To disassemble the basket, it is necessary to have it in the lower position, otherwise the lifting mechanism locks the basket, and it is not possible to disassemble it.

1. Press the snap to remove the plastic locking part. With the snap pressed, pull the plastic lock. Do this on the left and right-side rails.

2. Pull the basket as far out as possible without engaging the rotational lifting movement. Then on each side pull the snap 1 cm against middle of dishwasher and at the same time pull the basket out minimum 1 cm.

3. To remove the basket, slide the rails on both sides to the interior of the dishwasher while holding the basket.

4. With the basket out, unsnap the bracket from the basket.

Repeat all steps in reverse order to assemble again.