Dishwasher door shifts up during a wash cycle
Resolution
Issue:
- Dishwasher door shifts up during a wash cycle
Applies to:
- Integrated dishwasher
- Freestanding dishwasher
Resolution:
1. Contact the installer.
If your integrated dishwasher has been installed recently, the door panel may be too heavy, or the appliance may not have been installed correctly.
2. Check and, if necessary, wash out the spray arms, and clean the filters at the bottom of the unit in accordance with the user manual before using the appliance again.
If the appliance has been installed correctly, the problem may be blocked or clogged spray arms.
3. Contact an Authorized Service Center.
If your dishwasher is not integrated or recently installed, the dishwasher must be inspected and repaired by an engineer.
Was this article helpful?
Related Articles
- Symbols and programmes on your Electrolux dishwasher
- Dishwasher displays error code i23, not draining
- Dishwasher settings reset after each cycle
- Dishwasher does not beep at the end of the cycle
- Dishwasher is leaking
- Dishwasher does not switch on, no light on the panel
- It takes too long for a dishwashing cycle to start
- Too much foam in the dishwasher during or after finish of the cycle
- Using dishwashing multi-tablets
- Dishwasher displays error message i30, drains constantly
Related Articles
- Symbols and programmes on your Electrolux dishwasher
- Dishwasher displays error code i23, not draining
- Dishwasher settings reset after each cycle
- Dishwasher does not beep at the end of the cycle
- Dishwasher is leaking
- Dishwasher does not switch on, no light on the panel
- It takes too long for a dishwashing cycle to start
- Too much foam in the dishwasher during or after finish of the cycle
- Using dishwashing multi-tablets
- Dishwasher displays error message i30, drains constantly