Washing Machine - How to replace the temperature probe (3)

Resolution

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF PINCHING

Wear safety gloves if you perform maintenance or repair work involving belts.

WARNING! NOT INTENDED FOR CHILDREN

Keep all small parts and packaging out of reach of children under 3 years due to choking hazard. Installation and use should be performed by adults only.

-

Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE TEMPERATURE PROBE NTC

1. Unscrew the two 8mm screws on the back of the washing machine lid and slide back to release.

2. Open the detergent drawer, press down the push button at the back and pull the drawer out and away from its housing.

3. Unscrew the five PH2 screws holding the control panel cross bar and the two PH2 screws in the drawer housing.

4. Pull the control panel towards you to release.

5. Carefully disconnect wiring connectors from the temperature probe. Be careful not to damage the connectors.

(Note: Take a photo before starting to ensure that all the wiring connectors are returned to their correct positions).

6. Unscrew the two PH2 screws and lift out the temperature probe NTC to remove.

7. Remove the NTC gasket and transfer to the new NTC.

8. When assembling, repeat steps in reverse order.