Washing Machine - How to replace the electric valve (5)

Resolution

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF PINCHING

Wear safety gloves if you perform maintenance or repair work involving belts.

WARNING! NOT INTENDED FOR CHILDREN

Keep all small parts and packaging out of reach of children under 3 years due to choking hazard. Installation and use should be performed by adults only.

-

Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE THE ELECTRIC VALVE

1. Unscrew the two PH2 screws on the back of the lid and slide the lid back to release. Ensure the water is isolated and unscrew the inlet hose from the back of the machine. Note: When reinstalling ensure the inlet hose is fully screwed on to prevent any leaks.

2. Carefully disconnect the three wiring connectors from the electric valve, by pushing up the tab on the valve and sliding out the wiring connector. Be careful not to damage the connectors.

(Note: Take a photo before starting to ensure that all the wiring connectors are returned to their correct positions).

3. Carefully pull the valve towards you to release the securing tabs and rotate the valve to release the catches into the body of the appliance to remove the valve.

4. Angle to valve up and use pliers to release the two jubilee clips for the internal inlet hoses, then slide the inlet hoses down and off the valve to release the valve.

6. When reassembling, repeat steps in reverse order.