Washing machine - How to replace the control panel (3)
Issue
How to replace the control panel
Applies to:
- Washing machine
Resolution
Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/
WARNING! RISK OF ELECTRIC SHOCK
Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
WARNING! RISK OF INJURY
Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.
WARNING! RISK OF EYE INJURY
Wear safety glasses if you perform maintenance or repair work involving springs.
WARNING! RISK OF PINCHING
Wear safety glovesif you perform maintenance or repair work involving belts.
WARNING! CHOKING HAZARD
Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.
Only adults should use or install the product.
Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.
Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.
Do not use or install the product if damaged.
Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.
HOW TO REPLACE CONVEYOR, DETERGENT DISPENSER
1. Open the detergent drawer and push the tab at the back left of the drawer to release the detergent drawer.
2. Unscrew the two screws on the back of the washing machine lid and slide back to release.
3. Unscrew the three 7mm screws at the top of the control panel.
4. Unscrew the two PH2 screws in the detergent drawer housing and the four Torx 20 screws on the cross bar.
5. Use a flat bladed screwdriver to release the clip holding the detergent dispenser to the control panel. Pull the control panel towards you to release the control panel.
6. Remove the wiring, making a note of the position of the various connectors
7. Using a screwdriver, release the fixing clips and concurrently raise the entire board assembly until it is fully removed.
8. To remove the selector board and respective dial, loosen the two screws that secure the board to the control panel (do not loosen the central screw). Move the clips that secure it in place and raise it. In addition to the board, the selector dial will also be removed: to remove the dial, simply slip it off the pin.
9. When assembling, repeat steps in reverse order.