Washing machine displays error message E90, E91, E92, E93 or E94
Resolution
Issue
- Washing machine displays error message E90, E91, E92, E93 or E94. It indicates configuration / communication problems with the electronic parts.
Applies to
- Front loader washing machine (integrated and freestanding)
- Top loader washing machine
Resolution
1. Reset the appliance.
Remove the plug from the socket, wait 30 seconds and then plug it in again.
2. Contact an Authorized Service Center.
If the above suggestion did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- Cleaning the washing machine’s rubber seal if it's dirty
- Washing machine does not drain, displays error code E20, E21 or C2, emits 2 beeps / 2 flashes
- Connected appliances - The application cannot connect to the appliance
- How to reset WiFi network settings on my Electrolux washing machine?
- Washing machine displays error message E10, E11, C1 or emits 1 beep / 1 flash
- The "drum cleaning" icon shows on the washing machine display
- Washing machine stops in the middle of a cycle
- Where can I find appliance's PNC number?
- Washing machine’s fluff filter is jammed, cannot be removed
- White clothes turn grey after washing in my washing machine / washer dryer