Tumble Dryer - How to replace the motor fixing bracket

Resolution

Always refer to the safety information in your product’s user manual before carrying out any repair or maintenance work. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before carrying out any repair or maintenance work, switch off the appliance and unplug it from the mains socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances, it is safest to have two people move them. Always wear safety gloves and safety footwear. Wear safety gloves at all times to protect against cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you carry out maintenance or repair work involving springs.

WARNING! RISK OF PINCHING

Wear safety gloves if you carry out maintenance or repair work involving belts.

WARNING! NOT INTENDED FOR CHILDREN

Keep all small parts and packaging out of reach of children under 3 years of age due to the risk of choking. Installation and use should be carried out by adults only.

-

Always empty all water from the appliance, for example, from the tumble dryer water container. Any maintenance should be carried out with the appliance standing upright. Residual water could damage the electronics if the appliance is placed on any of its sides.

Make sure to use the product only for its intended purpose and check that it is a compatible part for the product in question.

Do not use or install the product if damaged.

Please note that self-repair or non-professional repair can have safety implications if not carried out properly and may void the warranty. It is essential to have the necessary expertise.

HOW TO REPLACE THE MAIN MOTOR MOUNTING BRACKET

1. Unscrew the Torx 20 screw in the condenser drawer housing. Then unscrew the two Torx 20 screws at the back of the appliance lid and slide the lid backwards to release it.

2. Unscrew the four Torx 20 screws on the back of the right-hand side panel and the two Torx 20 screws on the top of the right-hand side panel.

3. To remove the right-hand side panel, pull the panel upwards and away from the body of the machine to release it from the securing tabs at the bottom and side.

4. NOTE: When refitting, slot the side panel into the three bottom tabs and the three side tabs, ensuring that the panel is flush with the body of the appliance.

5. Unscrew the two Torx 20 screws securing the capacitor and wiring housing, then pull it towards you to release it.

6. Twist the motor backwards to stretch the retaining spring, while simultaneously pulling the belt off the motor shaft to release the drive belt.

7. Unscrew the two PH2 screws securing the two fixing brackets to the machine housing.

8. Lift the front of the fixing bracket and pull it towards you to unhook and release it. Note: When refitting, ensure that the back of the fixing bracket is securely fitted into the retaining hole.

9. . When assembling, repeat the steps in reverse order.