Tumble dryer does not switch on after a drying cycle
Resolution
Issue:
- Tumble dryer does not switch on after a drying cycle. It indicates a technical problem with the appliance.
Applies to:
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution:
1. Contact an Authorized Service Center.
We recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- AEG Tumble dryer stops after a few minutes of the cycle
- Tumble dryer emits unpleasant smells
- Tumble dryer displays a padlock
- Tumble dryer does not start / does not work
- Tumble dryer drum does not rotate, no error message
- Cleaning tumble dryer filters and condenser
- Tumble dryer does not heat up
- How to reset WiFi network settings on my Electrolux dryer
- Start - Pause LED flashes on tumble dryer
- What can water from a tumble dryer be used for?
Related Articles
- AEG Tumble dryer stops after a few minutes of the cycle
- Tumble dryer emits unpleasant smells
- Tumble dryer displays a padlock
- Tumble dryer does not start / does not work
- Tumble dryer drum does not rotate, no error message
- Cleaning tumble dryer filters and condenser
- Tumble dryer does not heat up
- How to reset WiFi network settings on my Electrolux dryer
- Start - Pause LED flashes on tumble dryer
- What can water from a tumble dryer be used for?