Tumble dryer displays error code E70
Issue
- Dryer shows error message E70 on the display
- E70 code
Applies to:
- Dryers
Resolution
1. Reset the appliance's control electronics by unplugging the appliance for 2 hours and then plugging it back in.
2. If this does not solve the problem and the error persists, contact our Consumer Care Centre
A service visit by one of our approved service providers is recommended.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Cause:
- Error code E70 indicates a problem with the temperature sensor
Was this article helpful?
Related Articles
- Tumble dryer displays error message E50
- Tumble dryer not drying, not drying properly, too long drying
- Tumble Dryer generates scraping/rubbing noise while drum rotating
- How to reset WiFi network settings on my Electrolux dryer
- AEG Tumble dryer stops after a few minutes of the cycle
- Tumble dryer displays error message EHO, EH0
- Tumble dryer does not stop when the cycle is finished
- When I open my Electrolux tumble dryer, there is a large amount of lint / fluff
- Tumble dryer displays error message E40
- Cleaning tumble dryer filters and condenser