Iron Aid tumble dryer displays error message Err
Resolution
Issue:
- Iron Aid tumble dryer displays error message Err
Applies to:
- Iron Aid tumble dryer
Resolution:
1. If the Iron Aid tumble dryer displays error message Err, fill the steam tank up to the MAX. level.
2. If the icons are still flashing, contact an Authorized Service Center.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Was this article helpful?
Related Articles
- How to reset WiFi network settings on my Electrolux dryer
- Start - Pause LED flashes on tumble dryer
- Tumble dryer displays a padlock
- How to change the dryer door opening directions?
- Tumble dryer displays error message E60 and does not heat up
- How long does a full load take to dry in a dryer – heat pump vs condenser?
- Tumble dryer drum does not rotate, no error message
- Tumble dryer not drying, not drying properly, too long drying
- When I open my Electrolux tumble dryer, there is a large amount of lint / fluff
- AEG Tumble dryer stops after a few minutes of the cycle