Iron Aid dryer does not start
Resolution
If the Iron Aid tumble dryer does not start, fill the steam tank up to the MAX level.
- Check the contents of the condensation and steam water tank. This is also indicated by the LEDs on the right side.
- If the icons are still illuminated , contact an Authorized Service Center.
You can contact an Authorized Service Center by clicking on the link below.
Was this article helpful?
Related Articles
- Tumble dryer does not heat up
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer displays error message E20, C2 or emits 2 beeps / 2 flashes
- Tumble dryer displays error message C6
- AEG Tumble dryer stops after a few minutes of the cycle
- Tumble dryer does not stop when the cycle is finished
- Tumble dryer drum does not rotate, no error message
- Tumble dryer's drying results are poor and laundry is damp after drying
- Cleaning tumble dryer filters and condenser
- Tumble dryer displays error message E60 and does not heat up
Related Articles
- Tumble dryer does not heat up
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer displays error message E20, C2 or emits 2 beeps / 2 flashes
- Tumble dryer displays error message C6
- AEG Tumble dryer stops after a few minutes of the cycle
- Tumble dryer does not stop when the cycle is finished
- Tumble dryer drum does not rotate, no error message
- Tumble dryer's drying results are poor and laundry is damp after drying
- Cleaning tumble dryer filters and condenser
- Tumble dryer displays error message E60 and does not heat up