Washing machine pumps continuously and produces foam
Resolution
Issue:
- Washing machine pumps continuously and produces foam
Applies to:
- Front loader washing machine (integrated and freestanding)
- Top loader washing machine
Resolution:
1. Switch the machine off and clean the drain pump and filter.
If the washing machine pumps continuously and produces foam it indicates, a lot of soap which produces a lot of foam is used, causing the level system can become clogged.
Clean the pump and fluff filter, including the pump blade (if the pump blade is visible, rotate it with a pencil and refit the filter).
For detailed procedure refer to the user manual supplied with your appliance. Download the .
2. Run a hot wash (90 degrees) without any soap in order to flush any soap residues out of the machine.
3. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Was this article helpful?
Related Articles
- Connected appliances - The application cannot connect to the appliance
- Why is there water or moisture is in my washing machine before the first use?
- How to connect your appliance
- The lid on my top load washing machine will not close
- The washing cycle is longer / shorter than it says on the display
- How to clean and maintain your Electrolux washing machine and extend its life
- Washing machine displays error message E40, E41 or emits 4 beeps / 4 flashes
- The door of the washing machine cannot be opened
- Grey marks on laundry after washing in washing machine
- The washing machine drum resists when you try to turn it by hand