Washer dryer displays error message E90, E91, E92, E93 or E94
Resolution
Issue:
- Washer dryer displays error message E90, E91, E92, E93 or E94. It indicates configuration / communication problems with the electronic parts.
Applies to:
- Freestanding washer dryer
- Integrated washer dryer
Resolution:
1. Reset the appliance.
Remove the plug from the socket, wait 30 seconds and then plug it in again.
2. Contact an Authorized Service Center.
If the above suggestion did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- Washer dryer does not take detergents / water remains in the softener compartment
- LED flashes on the washer - dryer's display
- Washer dryer displays error message E10, C1 or emits 1 beep / 1 flash
- Drying cycle of washer dryer takes too long, too short or not drying at all
- Washer dryer displays error message E20 or C2, emits 2 beeps or 2 flashes
- Washer dryer displays error message E40 or emits 4 beeps / 4 flashes
- Wool clothing shrinks after washing in washer - dryer
- Washer dryer displays error message EF0, EFo, EF3 or emits 15 beeps / 15 flashes
- Washer dryer displays error message E30, C3 or emits 3 beeps
- Seal on the washer-dryer door is damaged