Tumble dryer displays error message "Err"
Resolution
Issue
- Tumble dryer displays error message "Err". It appears when there is an attempt at changing a cycle or settings after the cycle has started or chosen option cannot be used with the selected cycle.
Applies to
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution
1. Switch the dryer off and on, then select the desired cycle and options.
Additional information can be found in the user manual.
Download the .
2. Make sure that the door is fully closed before starting the programme.
Was this article helpful?
Related Articles
- Tumble dryer does not heat up
- AEG Tumble dryer stops after a few minutes of the cycle
- Cleaning tumble dryer filters and condenser
- When I open my Electrolux tumble dryer, there is a large amount of lint / fluff
- Tumble dryer does not stop when the cycle is finished
- Tumble dryer ends the programme immediately after the start
- Tumble dryer not drying, not drying properly, too long drying
- How long does a full load dry to dry take in a dryer - heatpump vs condenser?
- Tumble dryer drum does not rotate, no error message
- Tumble dryer displays error message EHO, EH0