Fridge freezer- How to replace the thermostat (6)
Applies to:
- Fridges / Freezers
Resolution
Always refer to the safety information in your product's user manual before carrying out any repair or maintenance work. https://www.electrolux.com/support/user-manuals/
WARNING! RISK OF ELECTRIC SHOCK
Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
WARNING! RISK OF INJURY
Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.
WARNING! RISK OF EYE INJURY
Wear safety glasses if you perform maintenance or repair work involving springs.
WARNING! RISK OF PINCHING
Wear safety gloves if you're doing any maintenance or repair work on belts.
WARNING! CHOKING HAZARD
Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.
Only adults should use or install the product.
Always empty the appliance of all the water, e.g. tumble dryer water container. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.
Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.
Do not use or install the product if damaged.
Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Having the necessary know-how is essential.
HOW TO REPLACE THERMOSTAT
1 Carefully unclip the thermostat housing cover from the four corners.
2. Unscrew and take out the light bulb.
3. Press in the tab with a flat screwdriver and slide the whole thermostat housing left to release it.
4. Carefully detach the thermostat housing wiring from the connector in the fridge liner. Gently draw out the thermostat capillary tube entirely from the fridge liner housing
5. Carefully lift the thermostat cover from the dial end of the housing first, then slide the cover right towards the dial end to remove the cover. (NOTE: Ensure wiring is correctly positioned through the gap in the cover during reassembly, it may assist you to take a photo of this before it is removed).
6. Unclip the capillary from the thermostat housing and unwrap it from the coil towards the dial side of the thermostat. NOTE: When reassembling, make sure to carefully unroll the capillary and push it back into the holder on the thermostat housing
7. Pull off the control knob from the thermostat shaft. Use a 14mm ratchet to loosen the nut on the thermostat shaft, this will release the thermostat from the thermostat housing.
8. Carefully detach the wiring connectors from the thermostat. (Note: Snap a picture of the wiring setup/position before you disconnect them) Mind not to harm the connectors
9. Replace thermostat and reassemble. When reassembling, repeat steps in reverse order.